Technical Information Disclaimer
Aquenza Systems provides HDPE pressure systems supply coordination and preliminary specification alignment support.
Technical information provided on this website, in project discussions, or in preliminary supply responses is supplied as general guidance only to assist with understanding product categories, material classifications, and typical supply considerations.
1. Advisory Nature of Information
Any technical commentary, specification alignment review, or reference to SDR classifications, pressure ratings, operating conditions, standards, or product suitability is advisory in nature only and is based on the information made available to Aquenza Systems at the time.
Such information may not address all project-specific factors, including but not limited to:
• site conditions
• fluid media
• surge or transient pressures
• fabrication method
• installation method
• operating temperature
• elevation changes
• regulatory or authority requirements
2. No Engineering Certification
Aquenza Systems does not act as the design engineer or certifying authority for any installation unless expressly agreed in writing.
Information supplied by Aquenza Systems must not be used as a substitute for the judgement, design review, or certification of a suitably qualified engineer.
Final engineering design, approval, certification, installation, and operational responsibility remain with the appointed project engineer, contractor, or asset owner.
3. Standards and Pressure Ratings
Any reference to standards, pressure classes, SDR classifications, or pressure ratings is subject to applicable regulations, manufacturer documentation, project specifications, installation method, and operating conditions.
Pressure ratings and related performance data may require de-rating depending on temperature, media, fabrication, installation, and service environment.
4. Manufacturer Information
Where manufacturer technical data, product literature, or third-party documentation is provided, that information remains subject to the manufacturer’s published specifications, limitations, and warranty terms.
Aquenza Systems does not warrant that third-party information is complete, current, or suitable for every application.
5. No Warranty as to Results
Except to the extent required by law, Aquenza Systems gives no express or implied warranty as to the accuracy, completeness, or results obtained from the use of technical information supplied through this website or in preliminary project discussions.
6. Limitation of Liability
To the maximum extent permitted by law, Aquenza Systems will not be liable for any direct, indirect, incidental, or consequential loss, cost, damage, or claim arising from reliance on technical information, preliminary review commentary, or general guidance supplied by Aquenza Systems.
7. Updates
Aquenza Systems may amend technical information, specifications, or website content without notice as part of ongoing business and documentation updates.
8. Contact
If further technical clarification is required, users should seek advice from a suitably qualified project engineer and may also contact Aquenza Systems at:
info@aquenza.com.au